Safety Informations - J.P. SELECTA 2000150 Manual Del Usuario

*English Manual
SAFETY INFORMATIONS
The freezers contains environmentally friendly but flammable refrigerants. It means danger of explosion if
for any reason the refrigerants escape from the system.
The refrigeration system must never be accessed by unauthorized personal.
When transporting and installing the unit, ensure that no part of the tubing system is damaged.
If the tubing is damaged and leak occurs, avoid any ignition sources and naked flames near the unit, and
ventilate the room immediately.
In order to avoid formation of flammable gas/air mixtures in case of a leak from the refrigeration system, the
3
room where the unit is placed must have a volume equivalent to 1m per 8gr of refrigerant in the cabinet.
WARNING!!!
The ventilation openings must never be covered or blocked.
Never use a stream or water cleaning device during cleaning or defrosting in order to avoid short circuits in
the electrical system.
Do not place any electrical devices in the freezer.
Products containing flammable gasses and explosives must not be stored in the freezer.
All units should be provided with installation and operating instructions. In addition to the Clearances
Installation, the instructions should contain such directions and information that the manufacturer
considers necessary for installation, maintenance, and use of the refrigerator.
Installation and operating instructions should be provided with cautionary statements concerning the
handling, moving, and use of the refrigerator or freezer to avoid either damaging the refrigerant tubing, or
increasing the risk of a leak.
The shipping carton of a refrigerator or freezer that employs a flammable refrigerant should be marked
"Caution ‐ Risk of Fire or Explosion due to Flammable Refrigerant Used. Follow Handling Instructions
Carefully in Compliance with the Government Regulations". The warning marking should also appear on the
shipping carton, see below.
The installation and operating instructions should indicate that component parts shall be replaced with like
components and that servicing shall be done by factory authorized service personnel, so as to minimize the
risk of possible ignition due to incorrect parts or improper service.