Cequent Performance Products 76015 Instrucciones De Instalación página 3

Always wear SAFETY GLASSES
when installing hitch
Scan for step by step
PHOTO installation
instruction or visit
http://www.cequentgro
up.com/qr-product.aspx
Conical washer
teeth side
against hitch
Figure 2a
1. Tow hook removal - use 16mm and 18 mm socket to remove (2) short bolts, (2) long bolts, and (2) flange nuts from tow hook on passenger side, see Figure 2a, 2b, 2c. Return
fasteners and tow hook to vehicle owner.
2. Hitch installation - raise the hitch into position and align bracket holes to outside frame rail holes. Inset bolt ① and block ② from inside of frame rail holes to the bracket holes,
and loosely secure conical washer ③ and nut ④ to the hitch, see Figure 1.
3. Tighten all M12 fasteners with torque wrench to 68 Lb.-Ft. (92 N*M).
Proper torque is needed to keep the hitch secure to the vehicle when towing.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or ball which has been
damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2016 Cequent™ Performance Products, Inc. - Printed in Mexico
Installation Instructions
PART NUMBERS: 76015, 84015
Fasteners
typical
both sides
①②
Rear
Figure 1
①
②
③
④
Frame rail
③④
Sheet 3 of 12 76015NP
Fastener Kit: 76015F
Qty. (6) Bolt M12
1.75x110 , CL10.9
Qty. (6) Block
.375 X 1.50 X 2.00
Qty. (6) Conical washer
1/2''
Qty. (6) Hex nut
M12x1.75, CL10
Figure 2b
Figure 2c
03-01-16 Rev. A