Publicidad
Idiomas disponibles
Idiomas disponibles
1. Lower or Remove the Spare Tire – Lowering or removing the spare tire
will help ease installation.
3. Install Hitch – While lifting the Hitch into position, install (1) supplied
M14 bolt with (1) 9/16" Lock Washer and (1) 9/16" Flat Washer into the
rear most weldnut on each side of the frame.
Rear Most Weldnut
©2016 Cequent™ Performance Products, Inc. - Printed in Mexico
Lowering Location
2. Remove the existing M14 bolts – At the rear of each side of the Frame,
remove (1) Factory M14 bolt and return it to the customer.
4. Install Remaining Fasteners – With the Hitch in position, install the
remaining fasteners; (3) 1/2 – 13 Carriage Bolts and (3) 1/4" Blocks inside
each side of the Frame and three (3) 1/2" Conical Washers and three (3)
1/2 – 13 Hex Nuts below the Hitch on each side of the Frame.
Remaining Fastener Locations
Sheet 4 of 15
76016NP
Existing
02-24-16
Rev. A
Publicidad
