Cequent Performance Products 36601 Instrucciones De Instalación página 4

1. Support and lower exhaust: Lower the exhaust by removing (4) rubber hangers, and support the exhaust to prevent it
from falling under it's own weight. Spraying a lubricant or soapy water on the metal hanger rod and the rubber isolator
helps removal.
3. Install fasteners: Feed the coiled end of the pull wire ⑤ through the forward attachment hole in the frame and out the access hole. Feed spacer ② onto the pull wire
⑤ and thread the carriage bolt ① onto the pull wire ⑤. Pull the pull wire ⑤ with fasteners into location through the hole. Leave pull wire ⑤ attached. Repeat the
same process on the both frame rails. See figure 2. Using the reverse pull wire procedure thread carriage bolt ① onto the pull wire ⑤ and feed it into the access hole on
the frame rail then feed the spacer ② onto the pull wire ⑤ and feed it into the access hole and pull the carriage bolt ① into position through the spacer. Leave the pull
wire ⑤ attached. See figure 3.
©2017 Cequent™ Performance Products, Inc. -
Printed in Mexico
2. Remove plastic rivets: If present remove
the plastic rivets that fasten the fascia tabs
to the vehicle. Note: Remove the center of
the rivet with a flat screwdriver. Keep for
re-installation.
Sheet 4 of 18 36601NP 3-10-17 Rev. A