K'nex Building Basics - K'Nex 15142 Manual De Instrucciones

BUILDING
BASICS
Ready, Set, Build
To begin your model, find the
follow the numbers. Each piece has
its own shape and color. Just look at
the pictures, find the pieces in your
set that match and then connect
them together. Try to face your
model in the same direction as
the instructions
while you build.
Flexi-rods
A Flexi-rod is a rod that you
bend to make curves. It will
be easier to attach to your
model if you bend
it back and forth
first.
4
4
"Hi! I'm your K'NEX Building Buddy.
When you see me in the instructions,
you'll want to pay close attention to
the details being pointed out."
Movin' On
1
and Faded colors show you this section
is already built. You'll want to
connect the new section to the
place where the arrows are pointing.
The new pieces you add and the
place where they connect will be in
full color.
2
1
3
Tubes and
Holders
Make sure all Tubes and Holders are
aligned in the grooves. Push the yellow
Tubes all the way into the yellow
Holders until they are tight.
ALWAYS attach the yellow Holders to
the model before you attach the K'NEX
parts to them.
4
-
1 3
Connectors
There are blue and silver Connectors
with special long slots. They slide
together as you see in the pictures.
Push these parts together until you
hear a "click."
Spacers
There are places in your
model where you need
to add blue and silver
Spacers. Be sure to
use the right color and
count them carefully.