ASROCK X99 WS-E-10G Manual Del Usuario página 31

1. High Deinition Audio supports Jack Sensing, but the panel wire on the chassis must sup-
port HDA to function correctly. Please follow the instructions in our manual and chassis
manual to install your system.
2. If you use an AC'97 audio panel, please install it to the front panel audio header by the
steps below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for the HD audio panel only. You don't need to connect
them for the AC'97 audio panel.
E. To activate the front mic, go to the "FrontMic" Tab in the Realtek Control panel and
adjust "Recording Volume".
Chassis Speaker Header
(4-pin SPEAKER1)
(see p.1 or p.4, No. 23)
Chassis, Power and SB
Fan Connectors
(4-pin CHA_FAN1)
(see p.1 or p.4, No. 37)
(3-pin CHA_FAN2)
(see p.1 or p.4, No. 22)
(3-pin CHA_FAN3)
(see p.1 or p.4, No. 12)
(3-pin PWR_FAN1)
(see p.1, No. 45 or
p.4, No.44)
(3-pin SB_FAN1)
(see p.1 or p.4, No. 17)
DUMMY SPEAKER
1
+5V DUMMY
FAN_SPEED_CONTROL
CHA_FAN_SPEED
+12V
GND
FAN_SPEED
FAN_VOLTAGE
GND
CHA_FAN_SPEED
FAN_VOLTAGE
GND
GND
FAN_VOLTAGE
SB_ FAN_SPEED
1
X99 WS-E/10G / X99 WS-E
Please connect the chassis
speaker to this header.
Please connect fan cables
to the fan connectors and
match the black wire to
the ground pin. CHA_
FAN fan speed can be
controlled through UEFI
or A-Tuning.
29