ASROCK X99 WS-E-10G Manual Del Usuario página 40

2.10 SATA DOM (Disk on Module) Installation Guide
Installing the Serial ATA Disk On Module ( DOM )
1 2 3
SATAPWR1
SATA_PWR1
*he illustrations above are for reference only.
Warning: Incorrect setting of the SATA DOM Power Jumper (SATAPWR1) may cause
38
damage to the motherboard or your SATA DOM.
SATA_0
SATA_0
or
SATA_0
Step 1
Locate the SATA DOM Connector
(SATA_0) on the motherboard and
install the SATA DOM Card.
Step 2
Consult the documentation that
comes with your SATA DOM and
check whether or not Pin 7 requires
5V power supply.
If Pin 7 requires +5V power supply:
Move the jumper caps placed on
the SATA DOM Power Jumper
(SATAPWR1) from pins 2-3 (default)
to pins 1-2.
If Pin 7 does not require +5V power
supply:
Connect the SATA DOM power
cable to the SATA DOM Power
Header (SATA_PWR1).
*here is no need to change the
default jumper setting of the SATA
DOM Power Jumper (SATAPWR1).