Electrical Connection - Diamond ASD/50 Manual Del Usuario

3.- ELECTRICAL CONNECTION

AVOID ALL ACCIDENTAL GROUND STARTING. Before
connecting the machine, verify that all elements of machine
is good placed, otherwise it could cause a mishap.
CHECK THAT VOLTEGE OF ELECTRIC NETWORK is the
same of identification foil of machine.
CONNETION INSTALATION should possess differential
protection and own thermal magneto, also protected
upstream.
NO START MACHINE IF ELECTRIC CABLE OR PLUG
ARE DAMAGED.
CONECT PLUG to the electric network (220 V – 230 V)
•
Check that all elements of machine are in good position and that
machine's plug is connected to electric network of (220 V – 230
V).
•
The switch is located in a right lateral of the machine, to proceed to
the ground starting you presses the switch such a form that the
circulate is in the area that stands out. (FIG. 1)
•
For stop machine, presses the switch such a form that the line is in
the area that stands out. (FIG. 1)
•
The model F-50-A have an independent start switch for the feeder,
at the right top of the machine.
4.- ON AND OFF
off on
1
FIG.
11