Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
* ASSEMBLY OF THE MACHINE
Once the previous operations are completed you can proceed
to assemble the pieces again.
- Before beginning, check that the electric cable of the machine
is disconnected from the electric net and the switch is in off
position.
_ Place the cutting blade in the central groove and assure that
the piece makes ceiling. For security this operation should
always be carried out with protective gloves.
_ Put the ball and the hole again and insert them two by two.
Remember that the hole is in the upside and the ball in the
inferior part; the design of the machine it will prevent any
incorrect assembly in this sense.
_ Coils the four black screws that hold the squeezed
mechanism again.
_ Places each peel extractor in its lateral. VERY IMPORTANT:
These pieces should be placed correctly, to do it see the
section of "Part names" and the indicative sticker about
positioning of the peel extractors.
_ Makes sure that all the components are very placed. Proceed
to close the open protection cover and check that the cover
makes ceiling in the micro security contact.
_ With the machine closed place the clean filter and the cubes
to pick up the waste in the laterals of the machine.
* Before using the machine again, check carefully the perfect
operation of the safety devices. Check that the moving pieces
are in good conditions for working, that they don't block and that
they are not damaged.
All the components should be assembled appropriately and
have the requirements to guarantee the perfect operation of the
machine.
20
Publicidad
Tabla de contenido
