NGP 4441S Instrucciones De Instalación

7/8"
1 3/4"
1/2" Max Drop
1. TO FIELD SIZE: For single doors cut door bottom on end without actuator rod 1/8" shorter than distance between
stops on frame. For pairs cut 1/16" shorter than distance between stop on frame and meeting edge of door.
Maximum cut door bottoms 36" and longer = 4", shorter than 36" should not be field cut - order net length.
2. Trim gasket material to extend just beyond each end of the door bottom.
3. With door closed, position on push side of door with beveled actuator rod toward hinged edge. Align bottom
of case flush with bottom of door with 1/16" clearance between unit and stop on frame, mark screw holes.
4. Drill pilot holes for screws using 7/64" drill bit.
5. Install with screws provided.
6. Attach the snap-on cover.
7. Set for proper seal. To increase the drop, pull and turn the beveled actuator rod left. To reduce the drop, pull
and turn the beveled actuator rod right. Maximum drop = 1/2".
POSITIVE PRESSURE TESTED GASKETING MATERIALS
FOR APPLICATION TO HOLLOW-METAL-TYPE FIRE DOORS
RATED UP TO 3 HOURS AND WOOD-TYPE FIRE DOORS
RATED UP TO 1-1/2 HOURS.
Smoke and Draft Control gasketing (Category H) tested to UL 1784; meets
requirements of NFPA 105, IBC for use on "S" label doors.
3.15
National Guard Products Inc.
4441S, 4441WH
Automatic Door Bottom
WARNING: Maximum drop is 1/2". Adjusting beyond 1/2" drop will damage door
bottom, and void warranty.
HANDED - NOT FIELD REVERSIBLE
Unit is factory sized for use on pairs of doors, allowing for a 5/8" stop on frame.
Installation Instructions
FOR FIRE DOORS
CATEGORY H
1-800-647-7874