Filter Cleaning; Led Lights Replacing - Furrion FHO24R11-SS Manual Del Usuario

Filter Cleaning

IMPORTANT: Clean the hood and grease filters frequently
according to the following instruction. Replace grease filter
before operating hood.
Exterior Surfaces
IMPORTANT: Do not use soap-filled scouring pads,
abrasive cleaners, cooktop polishing creme, steel wool, gritty
washcloths, or paper towels.
● To avoid damage to the stainless steel, do not use
cleaners that contain chlorine.
● Liquid detergent or all-purpose cleaner: Rinse with clean
water and dry with soft, lint-free cloth. Use a stainless
cleaner to remove fingerprints.
Charcoal Filter Installation and Replacement
Installing the product in recirculation mode requires a
charcoal filter. Please call Furrion Support for ordering
information.
NOTE: The charcoal filter is not washable. It should last up to
6 months with normal use.
1. Press the two release tabs on the grease filters, then lift the
filter outward to take the filter off and then place it on a flat
surface. (Fig. 20 & Fig. 21)
Fig. 20
Fig. 21
2. Align the three slots to attach the charcoal filter, then
install or replace by anticlockwise. (Fig. 22)
NOTE: Turn it clockwise to remove.
Charcoal Filter
Fig. 22
10
3. Ensure the grease filters are dry before reattaching to the
range hood.

LED Lights Replacing

WARNING
ELECTRICAL SHOCK HAZARD
● Disconnect power before servicing.
● Replace all parts and panels before operating.
● Failure to do so can result in death or electrical shock.
CAUTION
BURN HAZARD
● Do not touch replacement lights with bare hands.
● Bulb may be hot, please take out the bulb when the bulb
is completely cooled.
NOTE: When the bulbs are damaged, they should be
purchase from Furrion and replace by a qualified service
technician.
1. Disconnect power.
2. Remove the grease filters. See page 7 Fig. 12 for grease
filter removal.
3. Gently push the LED lamps outward from the inside of the
range hood to release the lights from the housing. (Fig. 23)
Fig. 23
4. Disconnect the LED connector from the range hood
harness by pressing in on the connector lock (Fig. 24).
Fig. 24
5. Re-attach the new LED lights to the harness by
connecting the LED connector to the range hood harness.
Press the 2 connectors together until they lock together.
6. Gently press the LED LIGHT assembly into the range
hood light cutout until the LED is snapped into position.
7. Replace the grease filters.
8. Reconnect power to the range hood.
9. Press the light switch to turn on the range hood LED
lights.
Connector