Air Ventilation Setting - Furrion FHO24R11-SS Manual Del Usuario

3. Attach the range hood into the top or rear cutout area and
slide the range hood back until it contacts the wall, mark
the position of the screws of the range hood on the wall or
bottom of the cabinet using the tear shaped holes in the
range hood. The screw location to mark is shown in Fig 13
using the small area of the cutout. (Fig. 13)
Fig. 13
4. Fix the range hood onto the cabinet. (Fig. 14 & Fig. 15)
NOTE: DO NOT over tighten the screws.
− Cabinet or Wall Installation (Wood or drywall)
Fix the 4 screws (ST4x30mm) into the wall or bottom of
cabinet. Lift the range hood through LARGE HOLE and
slide to SMALL HOLE. Then tighten down the screws
to fix the range hood.
− Wall Installation (Concrete)
Drill four 8 mm holes to the proper depth. Insert the
drywall anchor into the 4 drilled holes, insert the 4
screws (ST4x30mm) into the anchors but leave a small
gap. Lift the range hood through LARGE HOLE and
slide to SMALL HOLE. Then tighten down the screws
to fix the range hood.
Top Installation
Fig. 14
Rear Installation
Fig. 15
5. Verify that the blower housing and ductwork are free of
debris and fan blades spin freely. Ensure the damper flap
is working correctly.
8
Screw Position
Power Cord Installations
1. Plug the power cord into a dedicated 120V, 60Hz, 15amp
electrical outlet.
NOTE:
− Use only the power cord supplied with the range hood.
− When the power cord is damaged, please contact
Furrion to replace.
2. See "Wiring Diagram" section for detail.
Wiring Diagram
Stop
Low Mid
KEY SWITCH
CN3
Control Panel
Motor 110-120V/1.5W
x 2
N L M H
M
C
Motor

Air Ventilation Setting

Outdoor Exhausting
The factory default setting is outdoor exhausting. Turn on the
range hood, then the air will be vented to the outside outlet.
(Fig. 16)
Fig. 16
Recirculating
Turn the adjuster to indoor position. Turn on the range hood,
then the air will be vented from the inside outlet. (Fig. 17)
Fig. 17
High Lamp
CN1
Lamp
L
N