Programming - Bticino Terraneo Instrucciones De Empleo

Programming

The device will indicate that each keystroke has been
accepted by means of a short audible signal and by a LED
above the numerical keypad, and will indicate that the new
programming has been accepted by means of three short
audible signals and by two flashes of the five red 1 LEDs.
In order to program the new "MASTER" code, the "A" and
"B" codes, the activation time of outputs "A" and "B", and
the monostable or bistable mode, one must follow the
sequences indicated below:
Programming of new "MASTER" code
(always 4 digits)
a) Type in
* *
changed)
b) Type in the sequence of digits of the previous "MASTER" code.
c) Type in
* *
will be changed)
d) Type in the desired sequence of the new "MASTER"
code (4 digits)
e) Type in
*
sequence).
(indicates that a previous code will be
(indicates that the previous "MASTER" code
(indicates the end of the programming
A B C
0000
** **
D E
MMMM
*
71