Assembly / Disassembling; 1- Components For The F1 Helmet; Installation Head Equipment In The F1 Helmet; Disassembling - MSA GALLET MICRO Manual De Instrucciones

ASSEMBLY / DISASSEMBLING

1- Components for an F1 Helmet:
Reference : GA1032x1xx
1
Specifications
1 MICRO-EARPHONE SET
2
3
2 BRACKET FOR ANTI-TEAROUT DEVICE
3 ANTI-TEAROUT DEVICE
4
4 SELF-BREAKING PLUG
5
5 YELLOW LOCATING LUG
6
7
Specifications
6 PTT (PUSH TO TALK) SET WITH CLIP
7 CONNECTOR PLUG
8
TRANSMITTER/RECEIVER SET (NOT SUPPLIED)
8
FIGURE 1
16
HEAD EQUIPMENT
TRANSMISSION EQUIPMENT
DEPENDING ON THE RADIO TYPE
2-1 Installation head equipment into an F1 helmet:
9
1
10
2
3
FIGURE 2
3
FIGURE 3

2-2 Disassembling:

Follow the instructions for assembly in the opposite way, disconnect the support to avoid
the cable from pulling out. Leave the this part in the helmet.
(See page 24)
Fix the micro-earphone set 1 (figure 2) into
the specially designed slot .This is located
9
on the right inside of the helmet (it also serves
to secure the head band).
In case that a neckskirt is used it is necessary to
make a horizontal cut of around 2 cm opposite to
the groove.
To anchor the bracket 2 for anti-tearout
device, unfasten the right side of the chinstrap
10 using a flat screw-driver.
Position the hollow section of the anti-tearout
bracket 2 over the male side of the press-
clip, then place the chinstrap into position.
Carefully slide the cable into the holding
groove of the anti-tearout device
3
a small length of cable to allow movement.
Click the anti-tearout device onto the
3
bracket 2 .
, leaving
17