Assembly / Disassembling; Disassembling - MSA GALLET OSTEO GA1022 Serie Manual Del Usuario

ASSEMBLY / DISASSEMBLING

1- Component parts of an F1 or F1A helmet:
Reference : GA1022x1xx
1
2
3
Specifications
1 FIXING LUGS
4
5
2 HELMET-MOUNTED PICKUP
3 LOUD-SPEAKER
6
4 BRACKET FOR ANTI-TEAROUT DEVICE
7
5 ANTI-TEAROUT DEVICE
6 SELF-BREAKING PLUG
8
7 RED LOCATING LUG
9
Specifications
10
8 PTT SET WITH CLIP
FIGURE 1
9 CONNECTOR PLUG
10 TRANSMITTER/RECEIVER SET (NOT SUPPLIED)
12
HEAD EQUIPMENT
TRANSMISSION EQUIPMENT
DEPENDING ON THE RADIO TYPE
2-1 Installation head equipment into an F1 or F1A helmet:
11
13
14
4
5
FIGURE 2
.

2-2 Disassembling:

Follow the instructions for assembly in the opposite way, disconnect the support to avoid
the cable from pulling out. Leave the this part in the helmet.
(See page 16)
On the right side of the helmet, pass the
12
helmet-mounted pickup
11 .
Position it in the centre of the netting fabric
12 and feed the four fixing lugs
the net to ensure good contact.
Fix the loud-speaker
designed slot 13 . This is located inside and
on the right of the helmet (and is also used to
secure the headband).
In case that a neckskirt is used it is necessary
1 2
to make a horizontal cut of around 2 cm
opposite to the groove
To anchor the bracket for anti-tearout device
4 , unfasten the right side of the chin strap
14 using a screwdriver. Position the hollow
part of the anti-tearout bracket
male side of the press-clip, then replace the
chin-strap.
Carefully slide the cable inside the holding
groove of the anti-tearout device
a small length of cable for manoeuvre.
Clip the anti-tearout device
4
tearout bracket .
FIGURE 3
2 under headband
1 through
3
in the specially
13
.
4 onto the
5 , leaving
5 on the anti-
13