Installation Head Equipment In The F2 Helmet; Disassembling - MSA GALLET MICRO Manual De Instrucciones

3- Component for an F2 helmet:
Reference : GA1032x2xx
11
Specifications
1
MICRO-EARPHONE SET
1
3
MICRO-EARPHONE POCKET
11
ANTI-TEAROUT DEVICE
3
4
SELF-BREAKING PLUG
4
5
YELLOW LOCATING LUG
5
6
7
Specifications
6 PTT SET WITH CLIP
7
CONNECTOR PLUG
8
8
TRANSMITTER/RECEIVER SET (NOT SUPPLIED)
FIGURE 4
18
HEAD EQUIPMENT
TRANSMISSION EQUIPMENT
DEPENDING ON THE RADIO TYPE
4-1 Installation head equipment into F2 helmet:
13
14
11
1
3 FIGURE 5
12
3
16
FIGURE 6
(See page 24)
Please note that for the sake of clarity, figures
5 and 6 show the headband is shown separate
from the helmet. However it should not be
removed from the helmet when installing the
head equipment.
Press the nipple of anti-tearout device
11
the hole of pocket .
13
15
3
11
12
Place the micro-earphone set 1
11
pocket .
Close the pocket using the press-stud
(figure 6).
Place the holding loop onto the headband
13
at a middle left position in the helmet. The
14
earphone must be turned towards the wearer's
head.
15
Close the loop using the press-stud.
Carefully slide the cable inside the holding
groove of the anti-tearout device 3
a small length of cable to allow movement
.
16

4-2 Disassembling:

Pull the small lip out of the pocket while pulling
the press-button.
3 into
into the
12
, leaving
19