Publicidad
Idiomas disponibles
Idiomas disponibles
SAVE THESE INSTRUCTIONS
Inflation
NEVER USE HIGH PRESSURE AIR TO INFLATE INFLATABLES. THIS CAN DAMAGE
YOUR PRODUCT AND VOID YOUR WARRANTY
• Inflate the air chambers with a HAND air pump.
Caution: Under and over-inflation of the boat will result in safety hazards. It is better to
check the pressure of the boat each time before using.
NOTE: Pressure gauge is for inflation purpose only, and the value of the pressure gauge is
just for reference, should not be used as a precision instrument.
• Never stand on or rest objects on the boat during inflation.
• Inflate bottom chamber and other accessories such as seat until it is stiff to the touch but
NOT hard.
NOTE: All drawings for illustration purpose only. May not reflect actual product.
Paddles Installation
Safety rope installation
Insert the rope into the holes of the D-buckles orderly, and then tighten the ends of the rope
to the D-buckles.
Caution: 1. Safety ropes shall be fitted to both sides of the bow and stern areas only and
shall not impede the normal operation of the craft.
2. Do check carefully if the saving rope is tightened well.
Seats and deck pack assembly
After the craft is inflated, connect the belts of the seat's to the side buckles on the craft,
make the deck pack is vertical. The location of the seats can be adjustable along with center
of the craft floor. Connect the deck pack to the D-buckle.
Repair
1. If there is a leak, take out the liner, spray water onto the chamber surface and look for air
bubbles. Soapy water works well.
2. If there is a small puncture, repair it according to the instruction on repair patch.
3. If the hole is too big to be repaired with the provided patch, purchase a Bestway repair kit
or send the boat to a speciality shop to make the repair.
Storage
1. Remove the paddles from the Velcro oar band; take down the deck pack and seats.
Note: Keep all accessories for future use.
2. Carefully clean the craft using a mild soap with clean water.
Note: Do not use acetone, acid, and/or alkaline solutions.
3. Use a cloth to gently dry all surfaces. Do not dry the product in direct sunlight.
Note: Also, never dry with equipment such as electric blowers. Doing so will cause
damage and shorten the craft's life span.
4. Deflate the hull chambers. Deflate all the hull chambers at the same time so the
air-pressure drops together. This will prevent damage from occurring to the boat inner
structures. Next deflate the floor.
5. Fold the craft from front to back to remove additional air. You can also use a pump to
drain any remaining air.
6. Store in a cool, dry place and out of children's reach.
Registration ( For US/Canada customers only )
If you need to register your boat, please have the boat Hull Identification Number and model
name ready and then visit bestwaycorp.com/support to obtain your Certificate of Origin,
PLEASE KEEP THIS MANUAL IN A SECURE PLACE, AND HAND IT OVER TO THE
NEW OWNER WHEN YOU SELL THE CRAFT.
4
Publicidad
