Clock Button - Giatsu RA1A-WIFI Manual De Usuario

Buttons on remote controller
I FEEL button
Press this button to start I FEEL function and "
After this function is set, the remote controller will send the detected ambient temperature
to the indoor unit and the unit will automatically adjust the indoor temperature according to
the detected temperature. Press this button again to close I FEEL function and "
disappear.
Note:
Please put the remote controller near user and confirm the unit can receive the remote code
when this function is set. Do not put the remote controller near the object of high temperature
or low temperature in order to avoid detecting inaccurate ambient temperature.
CLEAN button
● Press this button to start or cancel clean function.
● It is unable to set clean function when the unit is on; if the air conditioner runs in cool or
dry mode before turning off, press "CLEAN" button and show "
is on; press "CLEAN" button again, "
running 10 mins in clean function then turn off automatically.
● In the first power on, the clean function is off acquiescently.
● The clean function can not be set and displayed when the air conditioner is in auto, fan
and heat mode before turn off.

CLOCK button

Press this button to set clock time. "
Press "+" or "-" button within 5s to set clock time. Each pressing of "+" or "-" button, clock
time will increase or decrease 1 hour. Press this button again, "
on remote controller will blink. Press "+" or "-" button within 5s to set clock time. Press this
button another time, "
"-" button within 5s to set clock time. If hold "+" or "-" button, clock time will change quickly.
Release when reaching your required time. Press "CLOCK " button to confirm the time,
" " icon stops blinking.
Note:
● Clock time adopts 24-hour mode.
● The interval between two operation can't exceeds 5s. Otherwise, remote controller will quit
setting status. Operation for TIMER ON/TIMER OFF is the same.
TIMER ON button
This button can set the time for timer on. After pressing this button, "
"ON" and "
"TIMER ON" time. Each pressing of "+" or "-" button, the time will increase or decrease 1hour.
" and "
" icon on remote controller blinks. Press "+" or "- "button within 5s to set
" will be displayed on the remote controller.
" disappeared, then the clean function is off, or
"and " " icon on remote controller will blink.
" icon on remote controller will blink. Press "+" or
8
" will
" then the clean function
" and " " icon
" icon disappears,