RISCO Group Beyond DT Wired RK350DT Instrucciones De Instalación página 2

Description
The Beyond™ DT has been designed to provide enhanced 24-hour outdoor protection, with Active IR
Anti-mask capabilities. Integrated Dual Technology (DT) combines two K-band microwave channels
with two PIR sensors for better catch performance and pet immunity, minimizing false alarms. The
Beyond™ DT can also be installed on the RISCO Bus saving time and money.
Features include
•
PIR coverage: 12m, 90°
•
Two channel K band - MW detection (Sway Recognition)
•
Pet friendly (pet immunity)
•
Two correlated PIR Sensors
•
Light sensor for reducing false alarms due to sunlight
•
Active IR Anti mask
•
Mounting at 2.2m with optional swivel bracket
•
Designed for outdoor installation, UV resistant, IP 54
•
Cover and wall tampers
•
Optional Swivel Bracket (Model: RA350S)
Installation
Step 1: Preliminary Considerations
Select the mounting location for best coverage of the area that is to be protected (see Coverage
Patterns). Pay attention to the following:
•
Install the device at a height of 2.2m (7 ft 2 in). Any lower installation will reduce the detection
range accordingly.
•
For pet immunity, the height of an animal (without weight limitation) is up to 50 cm (1ft 6 in)
when the device is installed at 2.2 m (7ft 2 in). Any lower installation will reduce the pet
immunity accordingly.
•
Install the device in a location where the detector's field of view is clear of any static obstacles.
•
Mount the device so that walking traffic cuts across the beam pattern.
•
Do not install the device close to any moving objects.
•
Do not install more than one DT detector within a 1m radius.
Step 2: Mounting the Detector on Wall Bracket
1. Unscrew the fastening screw and remove the detector from the mounting bracket (see Figure 1).
2. Open the 5 knockout holes of the wall bracket, and use as a template for mounting (see Figure 2).
3. Insert external wiring through the cable channel on the back of the wall bracket (see Figure 2).
4. Secure the wall bracket to the wall (see Figure 3).
5. Connect the Terminal Block to the detector (see Figure 4).
6. Connect the terminal wiring (see Step 5a).
7. Set the DIP switch settings (see Step 5b).
8. Mount the detector to the wall bracket (see Figure 5).
2