Cequent Performance Products 41544 Instrucciones De Instalación

Step bumper
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: F41544
Wrenches: 3/4, 7/8, 21mm, 22mm
Drill Bits: 1/2"
Note: Fasteners typical both sides
Bumper bracket
Center
attachment
j
Qty. (4) Bolt 1/2-13 X 1.75
k
Qty. (4) Spacer with 17/32 hole
l
Qty. (4) Conical Washer
m
Qty. (4) Hex Nut 1/2-13
n
Qty. (2) Bolt M14 X 2.00 X 45
Note: On vehicles without factory bumper, it may be necessary to relocate license plate mounting bracket.
1. Remove existing M14 fasteners from end of each frame rail if present and return to customer.
2. Lift receiver into position, locating slots in receiver over weldnuts in vehicle frame.
3. Install M14 fasteners through receiver into weldnuts in vehicle frame.
Note: For vehicles w/o bumper, locate slots in receiver over fore/aft slot near end of frame. See Figure 2 for placement of fasteners
on vehicles w/o bumper.
4. Install remaining fasteners as shown.
Models with 6 ft. Bed
5. Using hitch as template drill a 1/2 hole thru frame at the center attachment both sides.
6. Install remaining fasteners as shown.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
2002, 2006, 2010, 2015 Cequent Performance Products – Printed in Mexico
z
Installation Instructions
CHEVROLET SILVERADO PICKUP
GMC SIERRA PICKUP
2500 H.D./3500 SERIES
j
k
l
m
Vehicles with bumper
Tighten all M14 CL10.9 fasteners with torque wrench to 115 Lb.-Ft. (156 N*M)
Tighten all 1/2 GR5 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)
1500/2500 SERIES
Do Not Exceed Lower of Towing Vehicle
Hitch type
Weight Distributing
Weight Carrying
Ball Mount
Wiring Access Location: PU3
Existing hole 8' bed
Drilled hole 6' bed
Existing weldnut
(vehicles with bumper)
p
o
Figure 1
n
o
Qty. (2) Lock Washer
p
Qty. (2) Spacer with 19/32 hole
q
Qty. (2) Flat Washer
r
Qty. (2) Nut M14 X 2.00
Sheet 1 of 3
Part Numbers:
Manufacturer's Rating or
Max Gross
Trailer WT (LB)
12,000 (5448Kg)
6000 (2724 Kg)
r
o
p
q
n
Figure 2
Vehicles without bumper
N41544 10-15-15
Form: F205 Rev A 5-6-05
41544
44657
Max Tongue
WT (LB)
1200 (546Kg)
600 (272 Kg)
Rev. C