Publicidad
Idiomas disponibles
Idiomas disponibles
Item e.
Wider reflector on
2011 – Present models
Fascia trim required.
Obtain vehicle owners
approval before cutting
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2007, 2008, 2012 Cequent Performance Products
Installation Instructions
Note: Fascia trim required
Plastic pop rivets
to be removed.
Do Not remove
Plastic pop rivets
Figure 3.
Figure 5.
BMW X5
Plastic wheel
well molding
Figure 2.
Figure 4.
Back-up sensor
(Optional equipment)
4" [101.6mm]
8" [203.2mm]
View from bottom of fascia
Sheet 2 of 6
Part Numbers:
Two retaining tabs under light
2011- Present model
Reflector
Bumper
fascia
Item b.
Higher up on
2011 – Present models
2" [50.8mm]
75600N
5-22-12
Form: F205 Rev A 5-6-05
75600
87455
44590
Rev. C
Publicidad
