Cequent Performance Products 75528 Instrucciones De Instalación

Frame
Bumper
rail
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 75528F
Wrenches: 18mm, 3/4"
Drill Bits: None
Exhaust not shown.
Sandwich spacer between
receiver and bumper
Use this combination for
bumpers with weldnuts.
Lower exhaust system for ease of installation.
j
Qty. (6) Hex Bolt M12X1.75X45 CL10.9
k
Qty. (6) Conical Washer
l
Qty. (2) Spacer
1. Remove the fascia door. Return to owner.
2. Detach the rubber exhaust hangers and lower the rearward portion of the exhaust ((2) on single exhaust, (4) on dual).
3. Raise hitch into position over the exhaust pipes aligning the slots in the hitch with the weldnuts in the bottom of the frame
rails.
Loosely install the M12 bolts and conical washers for existing weldnuts in bumper. Or install 1/2" bolts, conical washers and
4.
handle nuts for bumpers without existing weldnuts.
5. Install M12 bolts & conical washers through receiver at the bumper attachment. Sandwiching the spacer between the
receiver and bumper and into the weldnuts in vehicles bumper.
6. Loosely attach fasteners as shown, center hitch on vehicle and tighten fasteners to specifications below.
7. Raise exhaust system back into position.
Tighten all M12 bolts with torque wrench to 92 Lb.-Ft. (125 N*M), Tighten all 1/2"-13 Gr.5 bolts with torque wrench to 50 Lb.-Ft. (68N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
2007, 2008, 2009, 2010, 2011, 2012, 2013 Cequent Performance Products, Inc. – Printed in Mexico
©
Installation Instructions
Fascia
Chevrolet Traverse
Spacer
Bumper
.
GMC Acadia
Saturn Outlook
Buick Enclave
Do Not Exceed Lower of Towing Vehicle
Hitch type
Weight Distributing
Weight Carrying
Ball Mount
Wiring Access Location: SUV 1 , SUV2
Fasteners Typical Both Sides of Vehicle
If needed install handle nut through rectangular
access hole next to round hole. Typical.
Existing
weldnuts
l
Use this
m
combination for
l
l
bumpers without
k
weldnuts.
k
j
n
m
1/2"-13 Handle Nut
Qty. (2)
n
Hex Bolt 1/2"-13 X 1-3/4" Gr.5
Qty. (2)
Part Numbers:
Manufacturer's Rating or
Max Gross
Trailer WT (LB)
7500 (3405 Kg)
5000 (2270 Kg)
Frame rail
k
j
Sheet 1 of 3 75528N
Form: F205 Rev A 5-6-05
75528
87435
44569
78218 UH
Max Tongue
WT (LB)
750 (341Kg)
750 (341 Kg)
10-3-13 Rev. H