Regulating The Air Volume Flow En; Operation; Risk Of Injury - Binzel Abicor xFUME VAC FLEX Instructivo De Servicio

xFUME VAC FLEX
NOTICE
• Before establishing an electrical connection between the product and the mains, check whether the operating voltage
indicated on the nameplate corresponds to the mains voltage.
The mains cable and mains plug are pre-mounted. For the mains voltage and the fuse protection, please refer to:
 3.1 Technical data on page EN-7
 3.2 Nameplate on page EN-8
 13 Appendix
1 Plug the mains plug into the mains socket.
6.4 Regulating the air volume flow
The air volume flow can be regulated manually using the lever on the right hand side of the suction funnel. If the lever is in
vertical position, the valve is open and the extracted fumes can flow uninhibited.
If the lever is in horizontal position, the valve is closed and reduces the extracted air volume flow.
1
Lever
Fig. 4 Regulating the air volume flow

7 Operation

WARNING
Health risk due to harmful dust
Before and during operation, please observe the following:
• During operation, the complete extraction system must be kept closed.
• The service door must not be opened until at least one minute has passed since the extraction system was switched off.
CAUTION

Risk of injury

Injuries may be caused by improper handling.
• Do not draw in any flammable substances or liquids.
• Ensure sufficient ventilation while operating the extraction system.
 6.1 Transport and installation on page EN-10
BAL.0733.0 • 2019-09-18
1
2
2
Valve
7 Operation
1
2
EN - 13