Control Elements En; Putting Out Of Operation - Binzel Abicor xFUME VAC FLEX Instructivo De Servicio

8 Putting out of operation

NOTICE
• Only qualified personnel are permitted to perform work on the device or system.
• Consult the documentation for the welding components.
 6 Putting into operation on page EN-10
 Fig. 5 Control elements on page EN-14
1 Set the Device On/Off switch (4) on the extraction system to the "On" position.
7.1 Control elements
8
7
6
1 Extraction arm
2 Handle
Fig. 5 Control elements
1 Adjust the extraction arm (1) to accommodate the work task.
2 Adjust the extraction hood (6) to accommodate the work task. The extraction hood must be located approx. 20 cm above
the welding point during operation.
3 Establish an electrical connection.
4 Switch on the LED light (7) on the extraction hood (6).
5 Adjust air volume to the work task.
6 Use the On/Off switch (4) to switch on the device.
8 Putting out of operation
 Fig. 5 Control elements on page EN-14
1 Use the ON/OFF switch (4) to switch off the extraction system.
2 Disconnect the extraction system from the power supply.
EN - 14
5
3 Service door 5
4 On/Off switch 6
1
2
3
4
5
4 castors 7
Extraction hood 8
BAL.0733.0 • 2019-09-18
xFUME VAC FLEX
LED light
Light switch