Troubleshooting - Binzel Abicor xFUME VAC FLEX Instructivo De Servicio

xFUME VAC FLEX

10 Troubleshooting

DANGER
Risk of injury and device damage when handled by unauthorised persons
Improper repair work and modifications to the product may lead to serious injuries and damage to the device. The
product warranty will be rendered invalid if work is carried out on the product by unauthorised persons.
• Only qualified personnel are permitted to perform work on the device or system.
CAUTION
• Suitable safety measures must be taken before performing maintenance and cleaning work.
• Maintenance and cleaning work must only be carried out on the extraction system in areas with locally filtered forced
ventilation.
• Always wear your personal protective equipment when performing maintenance and cleaning work.
• Personal protective equipment consists of protective clothing, safety goggles, a class P3 respiratory mask, protective
gloves and safety shoes.
Please observe the attached 'Warranty' document. In the event of any doubts and/or problems, please contact your retailer
or the manufacturer.
NOTICE
• Consult the documentation for the welding components.
Fault
Insufficient suction volume.
Extraction system does not start.
Dust is escaping the system.
Tab. 6 Troubleshooting
BAL.0733.0 • 2019-09-18
Cause
• Extraction arm is blocked.
• Filter elements are full.
• Power supply defective.
• Electrical components defective.
• Motor protective switch defective.
• Filter elements are full.
• Service door not closed.
10 Troubleshooting
Troubleshooting
• Remove the blockage from the
extraction arm.
 Fig. 3 Attaching the extraction
hose on page EN-11
• Replace the filter elements.
• Check the electrical connection.
• Check the cable for damage.
• Check and replace if necessary.
• Check and replace if necessary.
• Replace the filter elements.
• Close the service door.
EN - 17