Zinco Fallnet SR Instrucciones De Montaje Y De Uso página 23

Inspection Chart
Eng
Product identification card in compliance with EN 365
Product
Manufacturer
Building project
Serial number(s)
Purchase date
Installation date
Used in combination with a load consisting of suitable bulk material, Fallnet
EN 795:2012 Typ E for fall protection on flat roofs. This device must only be used by a maximum of one person (up to 100 kg)
at any one time and in combination with personal protection equipment (PPE) in compliance with EN 363. The safety harness in
compliance with EN 361 must only be used together with tested and approved components.
Regular inspections
Inspections are required in order to ensure that the anchor device is functioning properly.
Such inspections must be carried out:
1. at least once a year
2. where required, e.g. if there is doubt about the proper functioning of the equipment
(see "Indications of restricted functioning")
After 10 years a complete inspection of the system Fallnet
The inspection works must be requested by the client/owner, are to be carried out by suitably qualified personnel who have been
authorised by the manufacturer and are to be recorded on the rear side of this inspection chart.
The following inspection works are required:
- visual inspection for damage and the position of the anchor device,
- visual inspection to ensure that there are no objects in the area of the
anchor point (radius of at least 0.5 m) that would prevent the supports folding
over as planned,
- manual inspection with regard to tensile loading of the anchor point, and
- sufficient coverage/bulk material height (see Installation Manual),
- legibility of the product identification label.
Attention:
Under no circumstances should the anchor device be used if there is any doubt as to its perfect condition and safety for use.
Please contact the client/owner immediately.
After 10 years, an overall inspection of the Fallnet
Fallnet SR
®
ZinCo GmbH, Lise-Meitner-Str. 2, 72622 Nuertingen, Germany
SR is to be carried out by the manufacturer.
®
SR system is to be carried out by the manufacturer.
®
SR is an anchor device in compliance with
®
23