Andis DBLC Instrucciones De Uso Y Cuidado página 3

16. WARNING: Never touch both terminals on clipper with
metal objects and/or body parts, as short circuit may
result. Keep away from children. Failure to comply with
these warnings could result in fire or serious injury.
SAVE THESE INSTRUCTIONS
THIS PRODUCT INTENDED FOR HOUSEHOLD USE
OPERATING INSTRUCTIONS
• The battery is to only be replaced by an Andis Authorized Service Station.
• The battery must be removed from the appliance before it is recycled.
• The battery is to be recycled as a lithium-ion battery.
UNIVERSAL AC/DC POWER ADAPTER
1. Remove the wall adapter and charger from the carton.
2. Note the charger comes standard with a universal AC voltage wall adapter and
interchangeable plugs.
3. To attach the desired plug to the wall adapter, align the slots on the plug to
the ribs on the wall adapter and slide into place. The plug will "click" into
place when properly attached. To remove, locate the button marked "push"
on the wall adapter. Press the button and slide the plug from the wall adapter.
The plugs for the various countries all attach and remove using the same
method (Figure A).
4. Connect the power cord to the back of the charger and then insert the
transformer into an AC outlet.
CHARGING UNIT
To charge, plug wall adapter into 100-240V, 50/60 cycle AC electrical outlet or
as noted on the unit. Make sure the proper input plug is attached to the wall
adapter. Plug power cord directly into back of charging stand. Place clipper into
the pocket on the charging stand. The clipper has electrical contacts that touch
electrical contacts in the charger. The weight of the unit will provide sufficient
contact.
Before using your clipper for the first time, make sure the battery has been fully
charged. Note that it is normal for the clipper and wall adapter to feel warm to
the touch when charging. This is especially true if the battery has been deeply
discharged as indicated by the Clipper Indicator Light turning red (Figure B) while
the clipper is running. The clipper should be charged with the switch in the OFF
position.
4
B
A
CLIPPER
INDICATOR
LIGHT
PUSH
POWER
SWITCH
SLIDING SPEED
ADJUSTMENT
BUTTON
E
D
1 2 3 4 5
CLIPPER INDICATOR LIGHT
(SPEED AND CHARGE LEVEL)
H I OIL
L M
To start clipper, move power switch to ON position. To stop clipper, move power
switch back to original position (Figure B).
CHARGING STAND INDICATOR LIGHTS
When the battery is charging, the Charging Indicator Light will turn red.
The Charging Indicator Light will turn green when the clipper is fully charged
(Figure C). Under normal operation the Indicator lights on the clipper will always
be dark when the unit is in the charger stand.
Note that the clipper can be removed at any time during the charging cycle
without harming the clipper or battery.
C
CHARGING
INDICATOR
LIGHT
F G
J K
REMOVE
REPLACE
N O
CORRECT INCORRECT
5