Publicidad
Idiomas disponibles
Idiomas disponibles
Frame Rail
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 75914F
Wrenches: 19mm
j
Qty. (6)
Hex Bolt, M12 x 1.25 x 35mm CL 8.8
1.
Remove the tow hook (shown above) from each side of vehicle frame and return to vehicle owner.
2.
Raise the hitch up and line up the two rearmost holes on each side bracket with the two rearmost holes on each side of vehicle frame. Install the supplied bolts
and conical washers.
3.
Torque all fasteners to correct torque specifications shown below.
Note: Check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water
and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do
not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©
2014 Cequent Performance Products, Inc. Printed in Mexico
Installation Instructions
Toyota Hilux SW4
Bumper Fascia
Existing weld nuts
k
j
Tighten all M12 x 1.25 CL 8.8 fasteners with torque wrench to 76 Lb.-Ft. (103 N*M)
Do Not Exceed Lower of Towing Vehicle
Manufacturer's Rating or
Hitch type
Weight Carrying
Ball Mount
Wiring Access Location: SUV3
Vehicle frame
Note: All Fasteners Typical Both Sides of Vehicle
k
Conical Toothed Washer, 1/2"
Qty. (6)
Sheet 3 of 3
75914N
Part Numbers:
75914
Max Gross
Max Tongue
Trailer WT (LB)
WT (LB)
2205 (1000 Kg)
331 (150 Kg)
12-08-14
Rev. A
Publicidad
