Installation Instructions; Part Numbers - Cequent Towing Products 75155 Instrucciones De Instalación

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

Remove tow hook & electrical bracket (if present) from vehicle frame and return to owner with fasteners.

Note: If present, unplug wiring connector bracket from impact bar. Remove the two plastic wire holders that

hold the 7-way connector wires, and the plastic wire above the frame rail. This will allow the play needed to

move electrical plug.

On TOYOTA 4RUNNER Vehicles ONLY.- Trim fascia tabs (both sides) near the bottom of the impact bar as

needed. (As shown in Figure 2. Page 1).

Raise hitch into position, making sure the factory 7-way connector is above the crosstube of the hitch during

installation. Align side brackets with existing tow hook holes at end of frame rails. Install fasteners as

shown. (Figure 1. Page1)

Tape (1) 1/4" x 1" x 3" block to each handle-nut. Insert the handle-nut into slots located in the impact bar.

Install the 1/2"-13 hex bolt and 1/2" conical washer as shown. (Figure 1)

Place the factory 7-way connector into the electrical bracket provided on the hitch. Using (2) ¼" hex bolts

and flanged nuts, attach 7-way electrical plug to electrical bracket on the hitch.

Existing hex bolts,

M8 x 1.25

LEXUS GX470 VEHICLES ONLY

Remove the (6) bolts holding the (2) fascia support brackets. Return the fascia support brackets and fasteners to

vehicle owner for reinstallation if hitch is removed. (Figure 3. above)

Install hitch per steps 1, 3,4 on above. Step 2 is for the Toyota 4Runner only.

Install the zip cable ties (4) (Fig. 4 below) through the spare tire bracket (attached to the impact bar,not the spare tire)

creating a large loop. Feed the remaining (2) zip cable ties through the fascia tabs then through the large loop

{securing the (2) zip cable ties together}.

Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body

panels to prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety

precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.

This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C.

Regulation V-5 and SAE J684.

2006, 2007, 2008 Cequent Towing Products – Printed in Mexico