Installation Instructions; Part Numbers - Cequent Towing Products 75156 Instrucciones De Instalación

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

Spring shackle

bracket

Approximate location of

drilled hole thru spring

Shackle bracket and

Dampener.

Figure 3

View in direction

Of arrow "A"

NOTE: On Flareside models vibration dampener assembly cannot be re-installed with hitch, and therefore must be

permanently removed for hitch installation.

Remove lock washer and nut from rearmost bolt on driver's side frame rail which was finger-tightened in step 2 of hitch

installation.

Attach dampener bracket to dampener using (2) existing M10 fasteners as shown in Figure 2.

Raise dampener with bracket attached and secure with with ½" fasteners at rearmost driver's side attachment point as shown in

figure 2.

Drill 7/16" hole thru spring shackle bracket and adjoining face of dampener bracket as shown in Figure 3. Install existing M10

fastener as shown in figure 2.

Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to

prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working

beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.

This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5

and SAE J684.

2003, 2005 Cequent Towing Products