Publicidad
Idiomas disponibles
Idiomas disponibles
Always wear SAFETY GLASSES
when installing hitch
Figure 2
Scan for step by step
PHOTO installation
instruction or visit
http://www.cequentgro
up.com/qr-product.aspx
⑤③
Bumper
beam
Rear
1.
Bottom appearance panel removal – use flat head screwdriver to remove (2) plastic rivets attached on upper panel and take upper panel down, see Figure 2. Use 10 mm socket and philips screwdriver to
remove (4) bolts attached on lower panel and take lower panel down, see Figure 2.
2.
Hitch installation – raise the hitch into position and loosely install M12 bolt ① with washer ② at rearward vehicle cross frame weldnuts, and M12 bolt ① with washers ③④ at forward vehicle cross
frame weldnuts, see Figure 1. Insert bolt ⑤ and flat washer ③ into bumper beam and loosely secure it with flange nut ⑥, see Figure 3.
3.
Tighten all fasteners with torque wrench to 75 Lb.-Ft. (102 N*M).
Proper torque is needed to keep the hitch secure to the vehicle when towing.
4.
Lower panel trimming – trim lower panel as shown in Figure 4. Make additional trimming if needed.
5.
Reinstall the upper and lower appearance panel removed in Step 1.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or
ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2015 Cequent™ Performance Products, Inc. - Printed in Mexico
Installation Instructions
PART NUMBERS: 75229, 87693, 44781
Existing
weldnuts
Vehicle cross
⑥
②
Figure 1
①
Figure 3
frame
③
④
①
Sheet 3 of 12
Fastener Kit: 75229F
①
Qty. (4)
Bolt M12
1.75x35, CL 10.9
②
Qty. (2)
Conical washer
½''
③
Qty. (3)
Flat washer
½''
④
Qty. (2)
Lock washer
½ ''
⑤
Qty. (1)
Bolt
½-13-5, GR5
⑥
Qty. (1)
Flange nut
½-13, GR5
7''
5.5''
4.0''
1.5''
Figure 4
75229NP
10-08-15
Rev. A
Publicidad
