Cequent Performance Products 75229 Instrucciones De Instalación página 4

1. Bottom appearance panel removal – use flat head screwdriver to remove (2) plastic rivets
attached on upper panel and take upper panel down, see Figure 2. Use 10 mm socket and
philips screwdriver to remove (4) bolts attached on lower panel and take lower panel down,
see Figure 2.
4. Lower panel trimming – trim lower panel as shown in Figure 4. Make additional trimming
if needed.
4.0''
1.5''
©2015 Cequent™ Performance Products, Inc. - Printed in Mexico
7''
5.5''
2. Hitch installation – raise the hitch into position and loosely install M12 bolt ① and washers ②
③④ through bracket slot into frame weldnuts, see Figure 1. Insert bolt ⑤, and flat washer ③
into bumper beam and loosely secure it with flange nut ⑥, see Figure 3.
3. Tighten all fasteners with torque wrench to 75 Lb.-Ft. (102 N*M).
Proper torque is needed to keep the hitch secure to the vehicle when towing.
5. Reinstall the upper and lower appearance panel removed in Step 1.
Sheet 4 of 12 75229NP 10-08-15 Rev. A