Original instructions: English
Translation of the original instructions:
Other languages
Read "the Safety Instructions" booklet
and the following before using.
I. INTENDED USE
This tool is the Multi-Impact & Drill
driver that has 2 operation modes,
"Impact Driver mode" and "Drill Driver
mode". The modes can be selected by
sliding the impact/drill driver switch.
Read the Safety Instructions booklet
and the following before using.
II. ADDITIONAL
SAFETY RULES
1) Wear ear protectors when using
the tool for extended periods.
Prolonged exposure to high inten-
sity noise can cause hearing loss.
2) Be aware that this tool is always in
an operating condition, since it does
not have to be plugged into an elec-
trical outlet.
3) When drilling or driving into walls,
floors, etc., "live" electrical wires may
be encountered. DO NOT TOUCH
THE CHUCK OR ANY FRONT
METAL PARTS OF THE TOOL! Hold
the tool only by the plastic handle to
prevent electric shock in case you
drill or drive into a "live" wire.
All manuals and user guides at all-guides.com
- 9 -
4) If the bit becomes jammed, im-
mediately turn the trigger switch off
to prevent an overload, which can
damage the battery pack or motor.
Use reverse motion to loosen
jammed bits.
5) Do NOT operate the Forward/Reverse
lever or mode select switch when the
trigger switch is on. Damage to the
unit may occur.
6) During charging, the charger may
become slightly warm. This is nor-
mal. Do NOT charge the battery for
a long period.
7) When storing or carrying the tool,
set the Forward/Reverse lever to
the center position (switch lock).
8) Do not strain the tool by holding
the speed control trigger halfway
(speed control mode) so that the
motor stops.
Symbol
Meaning
V
Direct current
n
No load speed
0
Revolutions or reciprocations
-1
... min
per minutes
Electrical capacity of battery
Ah
Rotation only
Impact driver mode
To reduce the risk of
injury, user must read and
understand instruction
manual.
For indoor use only.
Volts
pack