Indicator Light; Changing Batteries; Charging Batteries - smith&nephew SPIDER2 Modo De Empleo

Indicator Light

The SPIDER2 contains a single, green indicator light.
Indicator Meaning
Light On - Battery is installed, power switch is in the ON
position.
Light Off - Battery is not installed correctly, power switch is in
the OFF position, or unit is defective.
Light Blinking - Battery is installed, power switch is in the ON
position and battery has low energy.

Changing Batteries

Batteries may be changed at any time; SPIDER2 will remain in its original state (joints
locked/ unlocked) once battery is removed. If changing battery during surgery DO NOT
change the state of the Power Switch.
To change batteries:
1. Press Battery Release Button.
2. Slide battery out of track on SPIDER2 (Figure 8).
Figure 8. Changing Battery Watch Indicator Light
WARNING: Do not change the state of Power Switch if the patient is
connected to the SPIDER2.
3. Do not place battery on charger until light is orange.
4. Insert charged battery; SPIDER2 can now operate again. If the Indicator Light is showing
a battery with low energy, replace battery. Failure to do so may result in the SPIDER2 not
being able to lock/unlock.

Charging Batteries

1. Choose appropriate A/C Power Cable (Figure 9) and plug into Battery Wall Charger
(Figure 10).
Figure 9. Charging Components
SPIDER2 Limb Positioner Instructions for Use
Figure 10. Connect Charger
2. Plug SPIDER2 Battery Charger into 100-240VAC/50-60hz power outlet (Figure 11).
Figure 11. Battery Charger plugged into wall outlet
3. Place the SPIDER2 Battery Pack onto the Battery Charger Adapter and slide down to lock
in place. Do not place battery on charger until light is orange (Figure 12).
Figure 12. Battery Charger with installed battery
4. The battery will be fully charged once the Battery Wall Charger light becomes solid
green. The SPIDER2 Battery Pack may be stored on the Battery Charger Adapter when
not in use.
The SPIDER2 Battery Charger has one indicator light.
Description of light signals on wall charger:
LED* Meaning
Orange No Battery
Orange Initialization
Red Fast Charge
Green/Orange Top-Off Charge
Green Trickle Charge (Charge Completed)
Red/Green Error
* LED Light Mode may take up to 15 seconds to change state.
English
126-99-01 Rev. C
5