Preparation For Welding - WELDY booster EX2 Manual De Instrucciones

Description of tool
4
3
2
1
11
1. Welding shoe
2. Hot air tube group
3. Tool rest
4. Welding rod opening
5. Hot air blower
Instruction for tool switch:
• For starting the tool press and hold
• For stopping the tool release
• While holding tool drive on/off switch (10)
mode.

Preparation for welding

Before turn on power supply, all switches have to be turned off and make sure potentiometer is at «0».
The hand extruder must not be operated in inflammable environments or where explosion hazards
exist. Ensure stable position during operation. The connection cable and the welding rod must remain
unimpeded and must not hinder the user or others during operation.
Ensure power supply voltage is single phase 220V~230V,
with minimum power load capacity of 3000 W.
All manuals and user guides at all-guides.com
5
4
10
6. Tail handle
7. Drive unit
8. Overload protection fuse
9. Locking device drive on/off switch
10. Tool drive on/off switch
tool drive on/off switch (10)
tool drive on/off switch (10)
press locking device drive on/off switch (9)
12
6
7
4
8
9
11. Handle
12. Air temperature potentiometer
13. Hot air blower switch
13
3
for automatic
12