Operating Manual - WELDY booster EX2 Manual De Instrucciones

Operating Manual

Please read operating instructions carefully before use
and keep for further reference.
WELDY booster EX2 / EX3
Extrusion Welder
Application
Welding PE and PP thermoplastics for applications in:
• container engineering
• plastic fabrication
Warning
Caution
120
230
FI
All manuals and user guides at all-guides.com
(Original Operating Manual)
• pipeline construction
• landfill sites and abandoned polluted areas
DANGER!
Danger when opening up the tool, as live components and connections are
exposed. Therefore, before opening, unplug the tool to ensure disconnection
from the mains. Electronically conductive material (e.g. PE-EL) must not be welded.
Danger of fire and explosion! Incorrect use of the hand extruder (e.g. over-
heating of the material) can present a fire and explosion hazard, especially near
combustible materials and explosive gases.
Danger – can cause burns! Do not touch bare metal parts and emerging
material while hot. Allow the device to cool. Do not direct stream of hot air or
emerging material towards people or animals.
The voltage rating stated on the tool must correspond to the mains voltage.
If power failure occurs, the hot air blower switch and drive must be switched off
(release locking device).
For personal protection on building sites we strongly recommend the tool be
connected to a RCCB (Residual Current Circuit Breaker).
The tool must be operated under supervision. Heat can ignite flammable
materials which are not in view. The machine may only be used by qualified
specialists or under their supervision. Children are not authorized to use
this machine.
Protect tool from damp and wet.
Repairs should only be carried out by Weldy partners. Restricted to use with origi-
nal Weldy accessories and spare parts.
GB
10