Kohler K-4864 Guia De Instalacion página 3

Bidet
Ocultar thumbs Ver también para K-4864:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

2. Install the Bidet
Install the bidet faucet and drain according to the manufacturer's
instructions.
Set the bidet on the floor in its mounting location.
Trace the outline of the bidet base, and mark the location of the two
side mounting holes.
Remove the bidet from the mounting location.
Drill two 3/16" holes at the marked side mounting hole locations.
Thread the floor bolts (included) into the mounting holes.
Apply a bead of sealant around the base of the bidet, and carefully
align the bidet inside the outline drawn on the floor.
Position the bidet in the mounting location so both of the floor bolts
extend through the bidet side mounting holes.
CAUTION: Risk of personal injury or product damage.
Vitreous china can break or chip easily if the nuts are
overtightened or the product is handled carelessly.
Assemble the bolt cap bases, washers, and nuts. Hand-tighten the
nuts, then tighten an additional 1/2-turn with a wrench.
If the floor bolts extend more than 1/4" (6mm) from over the top of
the nut, loosen the nut and thread the bolt further into the floor.
Retighten the nuts, and install the bolt caps.
Kohler Co.
3
1020408–2–B

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

K-4876

Tabla de contenido