Craftsman professional 235.185930 Manual Del Propietário página 15

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

2. Place the assembled impact
mechanism down onto the
splined hub of the Rotor.
3. Position the Hammer Case
Gasket (19) against the face of
the Housing.
NOTICE:
Be sure that the
small tab on outside surface of
the Gasket is located in line
with the center of the Trigger.
See Figure 18.
Front of Housing
Gasket
Tab
Figure 18
4. Apply a thin film of Craftsman
No. 18830 Grease on inside
surface of the Hammer Case
Bushing (17), and place the
Hammer Case (16) down over
the Anvil and against the Motor
Housing.
5. Install the Hammer Case
Screws (12) and tighten them to
15 in-lb (1.7 Nm) torque.
15

Publicidad

Tabla de contenido
loading

Tabla de contenido