Placing Tool In Service - Craftsman professional 235.185930 Manual Del Propietário

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING
can cause severe personal injury or death if the warning is ignored.
CAUTION
is used to indicate the presence of a hazard which will
or can cause minor personal injury or property damage if the cau-
tion is ignored.
NOTICE
is used to notify people of installation, operation or main-
tenance information which is important but not hazard related.
This Craftsman Impact Wrench is
designed for use in general auto-
motive repair, tire service and
heavy duty fleet applications.
WARNING:
Important safety information en-
closed.
Read this manual before operating
tool.
It is the responsibility of an em-
ployer to place the information in
this manual into the hands of any-
one who operates this device.
Failure to observe the following
warnings could result in injury.

PLACING TOOL IN SERVICE

• Always operate, inspect and
maintain this tool in accordance
with all regulations (local, state,
federal and country), that may
apply to hand–held/hand–oper-
ated pneumatic tools.
• For safety, top performance,
and maximum durability of
is used to indicate the presence of a hazard which
parts, operate this tool at
90 psig (6.2 bar/620 kPa) maxi-
mum air pressure at the inlet
with 1/2" (13 mm) inside diame-
ter air supply hose.
• Always turn off the air supply
and disconnect the air supply
hose before installing, removing
or adjusting any accessory on
this tool, or before performing
any maintenance on this tool.
• Do not use damaged, frayed or
deteriorated air hoses and fit-
tings.
• Be sure all hoses and fittings
are the correct size and are
tightly secured. See Figure 1 for
a typical piping arrangement.
• Always use clean, dry air at
90 psig maximum air pressure.
Dust, corrosive fumes and/or
excessive moisture can ruin the
motor of an air tool.
• Do not lubricate tools with flam-
mable or volatile liquids such as
kerosene, diesel or jet fuel.
4

Publicidad

Tabla de contenido
loading

Tabla de contenido