Burner Cover Assembly; Troubleshooting Guide - Costco 1900617 Manual Del Usuario

Place the burner cover on the table top as shown in Figure11.
WARNING: BEFORE PLACING THE BURNER COVER ON, MAKE SURE
THE FIREPIT HAS BEEN SHUT OFF AND THE BURNER HAS
COMPLETELY COOLED DOWN.
PROBLEM
Burner Won't Light
Burner won't stay
lit after lighting
Our goods come with guarantees that cannot be excluded under the Australian Consumer
Law. You are entitled to a replacement or refund for a major failure and for compensation
for any other reasonably foreseeable loss or damage. You are also entitled to have the
goods repaired or replaced if the goods fail to be of acceptable quality and the failure does
not amount to a major failure.

BURNER COVER ASSEMBLY

TROUBLESHOOTING GUIDE

CAUSE
No propane gas at burner
No spark at electrode
Lack of oxygen
Thermocouple not in
Flame
Thermocouple connection
at the main control valve is
loose.
No fire ice on burner
Figure 11
REMEDY
Check that gas tank valve is open.
Turn control knob to "ON" and push
control knob in. Make sure tank has
propane gas.
Check that AA battery is installed with
negative (-) end first and has a charge.
Check that the wire is connected to the
ignition module. Check that the
electrode is not cracked or broken.
Remove excess or fire ice from around
the ignition well.
Check that the tip of the thermocouple
is even with the top of the ignition well.
Remove any fire ice from the ignition
well.
Tighten the thermocouple nut at the
back of the valve.
Cover the burner with fire ice per the
instructions.
11