ResMed AirSense 11 Serie Manual Del Usuario página 18

Disassembling
1. Hold the humidifier tub at the top and bottom, press it gently and pull it away from the device.
Note: take care when handling the humidifier tub as the humidifier tub may be hot. Allow 10 minutes
for the heater plate and any excess water to cool.
2. Open the humidifier tub and discard any remaining water.
3. Pinch the cuff of the air tubing, and gently pull it away from the device.
4. Hold both the cuff of the air tubing and the swivel of the mask, then gently pull apart.
5. Locate the outlet connector on the inside of the device and release it by pressing the clip firmly.
6. Remove the outlet connector by pulling it out through the outlet connector socket at the rear of the
device.
Cleaning
The following instructions are for home cleaning. Instructions for reprocessing devices intended for multi-
patient re-use can be found in the clinical guide.
You should clean the device, humidifier tub, air tubing, and outlet connector as described.
Daily:
1. Empty the humidifier tub and wipe it thoroughly with a clean disposable cloth. Allow it to dry out of
direct sunlight.
2. Refill the humidifier tub with distilled water.
Weekly:
1. Wash the components using one of the following options:
•
Wash the humidifier tub, air tubing and outlet connector in warm water using a household
dishwashing liquid. Components should not be washed in temperatures higher than 149°F (65°C)
OR
•
Wash the humidifier tub and outlet connector in a solution of 1 part vinegar and 9 parts water. The
air tubing should be washed in warm water using a household dishwashing liquid. The air tubing
should not be washed in temperatures higher than 149°F (65°C).
2. Rinse each component thoroughly in water.
3. Allow to dry out of direct sunlight or heat
4. Wipe the exterior of the device with a dry cloth.
Notes:
•
The humidifier tub may be washed in a dishwasher on the delicate cycle (top shelf only).
•
Do not wash the heated air tubing in a dishwasher or washing machine.
English 15