Connecting The Power Source - Irritrol LIFE 4 Guida Rapida

BACK MODULE

Connecting the Power Source

1. Route 10 cm of the transformer wire cable into the controller through the conduit
through the knockout (if conduit is not used).
2. Connect the transformer cable brown and blue to the terminals labeled "24 VAC".
3. Plug the transformer into the wall plug socket.
AUS: 230-240 VAC 50Hz
EU: 220-240 VAC 50Hz
US: 120 VAC 60Hz
Connecting the LIFE Programming
Module
In order to complete the LIFE Controller
assembly connect the Programming
Module onto the Back Module by simply
aligning the two and pressing them
together.
Programming Module may be
programmed also when detought from
back module. In order to work in this
way, programming module needs to
be recharged for 5 minutes minimum
(attached to the back module) the first
time it is operated or after 24H of power
absense.
Irritrol LIFE Controller 4 _ 6 _ 8
3