Timer Function; Emptying The Water Tank - Silvercrest SLE 200 A1 Instrucciones De Uso

Timer function

The appliance is equipped with a timer function that can be used with either of
the programmes. Switch-off times, ranging from 1 to 12 hours, can be selected.
Once the set time has elapsed, the appliance switches off permanently.
♦ While the appliance is running, press the
switch-off time between 1 and 12 hours. The selected switch-off time flashes
for approx. 5 seconds on the display w and then the current programme is
shown again. Additionally, a point appears on the right of the display w,
above the
♦ To end the timer prematurely, press either the
until
button z.

Emptying the water tank

The water tank 6 has a capacity of approx. 2.2 litres. When the water tank 6
is full, the appliance will beep for approx. 20 seconds and
display w. The dehumidification stops, the fan continues to run for approx. 3 minutes
and then switches off.
♦ Pull the water tank 6 carefully out of the appliance using the grips on the
side (see figure 1).
Fig. 1
♦ Tip out the water and replace the water tank 6 into the appliance. The
appliance resumes operation with the previously selected programme after
around 3 minutes.
■ 80 │ GB │ MT
symbol. This indicates that the timer function has been activated.
appears on the display w or switch off the appliance with the
6
button e repeatedly to set a
button e repeatedly
will appear on the
SLE 200 A1