Before Initial Use; Electrical Connection; Guidelines For Operation; Automatic Defrosting - Silvercrest SLE 200 A1 Instrucciones De Uso

Before initial use

♦ Place the appliance on a flat, dry and solid surface.
♦ Leave the appliance in the operating position for approx. 30 minutes to
allow the refrigerant to settle.
Check that the water tank 6 is correctly inserted.
♦
♦ Insert the plug into a mains power socket. You will hear a beep.

Electrical connection

ATTENTION
► Before connecting the appliance, compare the specifications for the
required input voltage on the rating plate with the intended voltage source
for operation. This data must match to prevent damage to the appliance.
► The power cable must always be easily accessible, so that the appliance
can be quickly removed from the mains in the event of an emergency.
► Make sure that the power cable is not damaged and is not routed over any
hot surfaces and/or sharp edges; otherwise it will become damaged.
► Ensure that the power cable is not taut or kinked.

Guidelines for operation

■ If the air in your living spaces is constantly excessively humid, the cause should
be identified and addressed. Sustained – year-round – dehumidifying is
generally not a good idea.
■ The optimal ambient temperature for dehumidifying the air is 5°C to 32°C.
Using a dehumidifier at temperatures below 5°C is redundant, as there is little
humidity in the air.
■ During operation, the room temperature may increase by 1°C to 4°C, depending
on the size of the room. This is normal.

Automatic defrosting

To ensure that the appliance does not ice up during sustained operation, it defrosts
automatically. The defrosting function is activated automatically and cannot
be switched on manually. Do not switch off the appliance during automatic
defrosting and do not disconnect the mains plug from the mains socket. During
defrosting,
but the fan continues to run. The duration of the defrosting process may vary. The
lower the ambient temperature, the earlier or more often the automatic defrosting
is activated. Once the defrosting process is complete, the appliance resumes
operation in the previously selected settings.
SLE 200 A1
appears on the display w. Dehumidification is briefly paused,
GB │ MT │ 77 ■