Initial Use; Use - Beurer FB 50 Instrucciones Para El Uso

6. Initial use

• Remove the packaging
• Check the device, power supply and cables for damage.
• Before plugging in the footbath fill it with warm water no higher than the level indicator (approx. 5 – 6 cm). The
foot rest should, however, be completely covered with water.
• Now plug the device into the mains power supply.
• Route the cable safely so that there is no risk of anyone tripping over it.
• Place the foot bath on a firm and level surface.
Make yourself comfortable in a chair and place your feet on the foot rest and apply slight pressure. Never stand up
in the foot bath. The rubber feet on the base of the unit prevent it from sliding.
Switch on the footbath by pressing the

7. Use

Vibration massage
Press the massage button (2) to switch on vibration massage. The footbath starts to vibrate. Place the soles of your
feet on the massage nubs and increase or reduce the pressure for the desired massage effect.
Bubble massage
Press the bubble button (3) to feed air onto the bubble bar for a soothing bubble massage.
Timer
You can set the desired time (20 – 60 minutes) with the timer function. Press the timer button (4) to extend the time
another 10 minutes. The timer is factory-set to 20 minutes. The footbath switches off automatically once the set time
has expired. Maximum duration is 60 minutes. Allow the footbath to cool for at least 15 minutes before using it again.
Temperature
The display shows the current water temperature. To change the temperature press and hold the temperature button
(5) until you have set the desired water temperature (35, 38, 42, 45, 48 °C). The most pleasant temperature is in the
range 35 – 42 °C, the maximum temperature is 48 °C.
The temperature is factory-set to 35 °C.
Magnetic field and infrared
The footbath has 6 magnets and 8 infrared lights integrated into the bath. They promote your circulation and
stimulate the reflex zones.
Massage roller
You can experience a special massage effect by moving your feet back and forth on the six massage rollers integrated
into the bottom of the footbath. The massage rollers can optionally be removed by pulling them firmly upwards.
Removable attachments
Place the desired attachment on the holder in the centre. Press the attachment lightly down with your foot to
activate the electric motor.
The brush attachment can be used to stimulate the reflex zones in the soles of your feet
The massage attachment provides a soothing massage for your feet and promotes the circulation.
The corn and callus remover is used to remove dead skin cells and calluses.
The electric motor is protected from overheating and has a maximum load capacity. The motor stops if it is over-
loaded or overheated. It can be used again after cooling down.
Note
• Massage of a specific point on the sole of the foot may influence the corresponding organ of the body.
However, we recommend studying relevant literature and asking your doctor before using point reflex
zone massage to achieve the desired effect.
• The footbath can also be used without water.
After use pour the water out over the narrow side (11) of the footbath. Do not allow water to come into contact
with the display.
button and set the desired function.
13