Prolonged Disuse; Instructions For Cleaning; Reminders For Cleaning - ALI PROXE70 74GFR Instrucciones Para Instalación, Uso Y Mantenimiento

•
The appliance is equipped with a manual reset safety
thermostat which interrupts heating when the operating
temperature exceeds the maximum permitted value.
•
You have to pay particular attention to the fact that
the old fat and oil and the dirt, have a reduced ignition
temperature and will increase its tendency to boil
suddenly and the foam, which results, may overfl ow.
FILLING AND EMPTYING THE WELL
Filling
Turn handle of the drain valve.
Fill the well until the water is level with or above the minimum
level ( bottom mark ) indicated on the rear wall of the well.
Emptying
•
Switch the heating off .
•
Wait for the oil to cool
•
Connect the extension (if present) to the drain valve.
•
Place a suitable receptacle to hold the drained oil under
the drain extension.
•
urn the drain valve handle slowly. Use caution when
carrying out this procedure. DANGER of scalding from
hot oil.
BURNER IGNITION AND EXTINCTION
The gas tap control knob has the following positions:
Off
Pilot ignition
100° Minimum cooking temperature
185° Maximum cooking temperature

REMINDERS FOR CLEANING

The manufacturer will not be liable for any damage or
injury resulting from failure to observe the following
rules.
•
Disconnect the appliance electrical power supply, if
present, before proceeding with any operation.
•
Clean the satin fi nish stainless steel exterior surfaces,
the cooking wells and the surface of the hotplates
every day.
•
At least twice a year, have an authorized technician
clean the internal parts of the appliance.
•
Do not use direct or high pressure water jets or steam
cleaners to clean the appliance.
•
Do not use corrosive products to clean the fl oor or shelf
beneath the appliance.
•
Do not use fl ammable products to clean the appliance.
SATIN FINISH STAINLESS STEEL SURFACES
•
Clean the surfaces with a cloth or sponge using water
and proprietary non-abrasive detergents. Follow the
28
Instructions for use
Pilot ignition
Press and turn the knob to position "
•
•
•
•
Main burner ignition
•
Switching off
To switch the main burner off , turn the knob to position "
To switch off the pilot fl ame, press and turn the knob to
position "

14. PROLONGED DISUSE

Before any prolonged disuse of the appliance, proceed as
follows:
•
•
•
•
Following prolonged disuse, proceed as follows:
•
•

Instructions for cleaning

•
•
•
COOKING TANKS
•
•
FILTERS
The use of oil fi lters prolongs the life of the oil and, if the oil
is reused, guarantees better cooking of the food. To clean
the fi lter, extract it from its seat; if the fi lter is greasy, wash it
with a degreasing soap, rinse and dry When the procedure
is con-cluded refi t the fi lter in its seat When the fi lter is
deteriorated it must be renewed
Press the knob down fully and
the piezoelectric igniter.
Hold the knob down for about 20 seconds before
releasing it. If the pilot fl ame goes out, repeat the
operation.
The pilot fl ame can be seen by opening the door.
The pilot light can be lit by bringing an open fl ame up to
the nozzle
Turn the knob to the chosen temperature setting for
cooking.
".
Clean the appliance thoroughly.
Rub stainless steel surfaces with a cloth soaked in
Vaseline oil to create a protective fi lm.
Leave lids open.
Close the valves and turn off the electrical power supply
at the main switch.
Inspect the appliance thoroughly before using it again.
Allow electric appliances to operate at the lowest
temperature for at least 60 minutes.
grain of the satin fi nish. Rinse repeatedly and dry
thoroughly.
Do not use pan scourers or other iron items.
Do not use chemical products containing chlorine.
Do not use sharp objects which might scratch and
damage the surfaces.
Clean the tanks by bringing the water to the boil, with
the addition of grease remover detergent if necessary.
Remove any limescale deposits with a proprietary
limescale remover..
".
light the pilot using
".