Luminous flux control
Art. 0827 809 119, Art. 0827 940 119
Press on/off switch 1 x = 50 % lumen
■
Press on/off switch 2 x = 100 % lumen
■
Press on/off switch 3 x = 0 % lumen
■
Art. 0827 981 119, 0981 181 119:
Press on/off switch 1 x = on
■
Press "+" or "-" to select 10 % - 100 % lumen
■
Press on/off switch 2 x = off
■
Attention!
Clean the device only when the mains plug has been removed.
Clean the lamp with hot water, or if necessary with a standard detergent.
■
Do not use any technical solvents, acetone, benzene, tetrachloromethane, etc.
Likewise, do not leave in contact with oils or grease for long periods.
■
A damaged lead may only be exchanged by the manufacturer or an authorized
■
service company.
The information in these operating instructions can be changed without prior notice.
Würth does not accept any liability for direct, indirect, accidental or other damage or
consequential damage which result from the usage or the application of the informa-
tion in these operating instructions.
If in spite of careful manufacturing and test procedures, the device becomes faulty, a
repair by Würth masterService should be arranged.
With any enquiries or spare parts orders, always quote the article number as given on
the device type plate.
Maintenance / Care
Disclaimer
Spare parts
13