Uline H-4564 Manual Del Usuario página 12

MEMORY RECALL
To view the totals in memory, press the M+
key while display reads zero, and display will
show "AC n" ('n' is current accumulation
times) and then the total in memory for 2
seconds. The scale then returns to normal.
TO CLEAR MEMORY
To clear the accumulated data in memory,
press the M+ key and the G/N key when
total weight value is displayed.
PRETARE
1. To set press and hold PT key for 3
seconds to display current tare value.
2. To manually key in a tare value, use TARE
key to select value and M+/ PT keys to
toggle between active digits.
3. After Pretare value has been entered,
press ZERO key.
4. Display now shows "Pts 0". Press TARE
key to select desired pretare item.
(0-9 preset items are available)
5. Once pretare item is selected, press ZERO
key to store pretare value in memory.
NOTE: Pretare value is displayed while
NET indicator is shown on display.
SELECT PRETARE
1. Press G/N key to ensure scale is in net
mode.
2. Press PT key. "Ptl 0" is shown on display.
Press TARE key to select desired stored
item (0-9). Press ZERO key to display
pretare value.
CLEAR PRETAREVALUE
1. Press PT. Display will show "Ptl 0".
2. Use M+/ PT buttons to select desired
pretare item (0-9).
3. Press ZERO key to display pretare weight.
4. Press and hold PT for 3 seconds and
follow steps in section I to set pretare
value to zero.
THERMAL PRINTER
NOTE: Thermal printer is located at
the bottom of the control panel.
Reorder item No. S-16160.
1. Open the paper roll cover by pulling
down the cover. (See FIgure 11)
12 OF 62
OPERATION CONTINUED
2. Insert paper roll. Feed the paper roll end
3. Close the cover tightly.
4. Press the M+/Print key to print.
PRINT OUT FORMATS
Format 1
Format 2
Format 3
PARAMETERS
The scale has parameters that can be set by
the user.
1. To set parameters, press the ZERO key and
Figure 11
through the cover. (See Figure 12)
Figure 12
TARE key at the same time.
Paper
Roll
Cover
Paper
Format 4
Format 5
0721 IH-4564