Infiniton GG-319 Manual De Instrucciones página 10

Check the Seal
Once the hob was installed, make sure all the connections are properly sealed, use a soapy water to test,
never use flame.
Electrical Connection
The hob fitted with a tripolar electrical supply cord which are designed to be used alternating
current .According to the indications on the rating plate located under the hob. The earthing wire can be
identified by its yellow-green colour.
In the case of installation over a built-in electric oven, the electrical connections for the hob and oven should
be independent, not only for safe purpose, but also be convenient to remove them in the future.
Electrical Connection for Gas hob
Fit the supply cord with a standard plug for the demand rate indicated on the rating plate or connect it
directly to the electrical mains. In the latter case, a single pole switch must be placed between the hob and
the mains, with a minimum opening between the contacts of 3 mm in compliance with current safety codes
(the earthing wire must not be interrupted by the switch). The power supply cord must be positioned so that
it does not reach a temperature in excess of 50℃ than room temperature at any point.
Before actual connection make sure that:

The fuse and electrical system can withstand the load required by the hob;

The electrical supply system is equipped with an efficient earth hook-up according to the norms and
regulations prescribed by law;

The plug or switch are easily accessible.
Important: the wires in the main lead are coloured in accordance with the following code:
Green & Yellow
Blue
Brown
As the colours of the wires in the main lead may not correspond with the coloured markings identifying the
terminals in your plug, proceed as follows: Connect the Green & Yellow wire to terminal marked "E" or
or coloured Green or Green & Yellow.
Connect the Brown wire to the terminal marked "L" or coloured Red.
Connect the Blue wire to the terminal marked "N" or coloured Black.
- Earth
- Neutral
- Live
10