How To Keep Your Gas Hob In Shape - Infiniton GG-319 Manual De Instrucciones

On those models fitted with a safety device
The knob must be pressed for about 6 seconds until the flame is lighted and warmed up.
On those models fitted with an igniter
The electric ignition button, identified by the
is pushed and turned in the counter-clockwise direction to the "High" setting.
To light a burner:
the High setting, keep press until the burner is lighted.
Caution:
If the flame goes out accidentally, turn off the gas with the control knob and try to light it again at
least 1 minute later.
To turn off a burner:
setting).
Before cleaning or performing maintenance on your gas hob, disconnect it from the electrical power supply
(included battery power).
To extend the lifespan of the gas hob, it is absolutely indispensable that it is cleaned carefully, thoroughly
and usually, please keep in mind to the following:

The enameled parts and the glass top, must be washed with warm water without using abrasive
powders or corrosive substances which could ruin them;

The removable parts of the burners should be washed usually with warm water and soap, make sure to
remove caked-on substances;

Automatic igniter pin, the end must be cleaned carefully and usually, make sure ignition keep working
normally.

Stainless steel top plate and other steel parts can be stained if keep touch with high concentration
calcareous water or corrosive detergents (containing phosphorus). To extend the lifespan, we advise
these parts be rinsed thoroughly with water and dry them by blowing, It is a good idea to clean up any
spills too.

After glass hob working, the surface must be cleaned by a damp cloth to remove dust or food residues.
Glass surface should be cleaned regularly with warm water and non-corrosive detergent.
First, to remove all food residues or greases with a cleaning scraper, e.g.
Cleaning scraper (not supplied) (Fig. 1).
While the cooking surface is warm, clean it with a suitable cleaning product and paper towels, then rub
with a damp cloth and dry surface. Such as aluminum foil, plastic items, objects made of synthetic
material, sugar or foods with a high sugar content that have been melted onto the surface, it must be
removed immediately.
While the cooking surface is still hot, clean it with a scraper and a transparent protective film which
prevent to make more dirt. This also protect the surface from damage caused by food with a high sugar
content.
Simply press the corresponding knob and turn it in the counter-clockwise direction to
Turn the knob in the clockwise direction until it is stopped (it should be on the "

How to Keep Your Gas hob in Shape

symbol, must be pressed first, then the corresponding knob
4
·
"